Fluke OF-500 OptiFiber, Technical Reference Handbook

Page: 60 / 282

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
2-14
Tutorial: Running an OTDR Test
The tutorial in this section familiarizes you with the tester
by guiding you through the following tasks:
•
Using the tester’s menu system
•
Connecting the tester to a cable
•
Running an OTDR test
•
Viewing the results in several levels of detail
•
Saving bi-directional test results
Required Equipment
•
OptiFiber tester set up as follows:
¾
Multimode module installed
¾
Charged battery attached or the ac adapter
connected
¾
Job settings configured as follows (see the
tutorial “Preparing to Save Tests” on page 2-11
for configuration steps):
•
START ID and STOP ID set to 03A-A01 and
03A-B06
•
A job folder with any name created on the
memory card
•
Your name as the operator
•
END 1 set to CLOSET; END 2 set to WORK
AREA
•
THIS END set to END 1
•
Fiber cabling to test: 50 m to 2 km (165 ft to 6500 ft)
of multimode fiber. If possible, select cabling that
has a connector somewhere along its length.
•
A launch fiber that matches the type of cable you
will test
•
Fiber cleaning supplies