Fluke OF-500 OptiFiber, Technical Reference Handbook

Page: 222 / 282

OF-500 OptiFiber Certifying OTDR
Technical Reference Handbook
11-4
4 On the LinkWare menu select Utilities > OptiFiber
Utilities > Create Software Update MMC .
5 Locate and select the .ofu file you downloaded; then
click
Open .
6 Locate and select the memory card drive; then click
OK . LinkWare unzips the update file and copies the
files to the memory card.
W
Caution
If you remove the memory card from the MMC
reader before the files are completely copied the
Windows operating system may report an error
and OptiFiber shows the message “Bad update
file”. If this happens, repeat steps 4 through 6;
then leave the card in the reader for a minute or
so to ensure the files are completely copied.
7 Put the memory card into the OptiFiber tester.
8 Install a module in the OptiFiber mainframe, then
turn on the tester.
9 Press F on OptiFiber; then select Install Software
Update . The tester makes initial choices on which
software to install based on the versions currently
installed in the mainframe and the module.
Generally, you should not change these choices
except to select languages to install or remove.
10 Press
E
Start to start the update process.
11 The OptiFiber tester reboots after the update is
complete. To verify the update, press
A Version
Info from the HOME screen.
12 If you have additional modules to update, insert each
module and repeat steps 9, 10, and 11.