Festo CPX-FB23, Electronic Manual

Page: 51 / 122

2. Commissioning
2−7
Festo P.BE−CPX−FB23−EN en 0308NH
The valves are configured according to the pneumatic
interface used:
Valves of type 12 (CPA) and type 03 (Midi/Maxi):
For extensions on the valve side the pneumatic interface
provides one single output module. The number of valve
coils is set in the pneumatic interface with a DIL switch
(grid 1 byte).
Valves of type 32 (MPA pneumatic modules):
From a technical point of view, the individual MPA pneu
matic modules each provide an electric module with digi
tal outputs for controlling the fitted valves.
Please note
If two addresses are assigned for one valve location, the
following applies:
lower−value address: pilot solenoid 14
higher−value address: pilot solenoid 12
Further information on the electric and pneumatic modules
can be found in the manual CPX I/O modules (P.BE−CPX−EA−..)
or CPX analogue I/O modules (P.BE−CPX−AX−..) as well as in
the relevant pneumatics manual.