Festo CPX-FB23, Electronic Manual

Page: 72 / 122

2. Commissioning
2−28
Festo P.BE−CPX−FB23−EN en 0308NH
2.1.7 Bus configuration and addressing
Before a slave can be connected to the CC−Link master,
various configuration settings must be made, e.g.:
the number of connected slaves
the number of stations to be connected to the system
again during a scanning cycle
the status if there is a CPU fault in the main computer
station data (settings of the slave):
the station type (CPX−FB23: (remote device station)
the number of stations occupied by the slave (1 ... 4)
CC−Link slave address (1 ... 64).
The configuration settings are saved in the master station
buffer memory. The settings can e.g. be set as follows (in
some cases depending on the master):
with the GX Developer (see following example)
by manual programming via PLC code (see section
Master station buffer memory").