1. Installation
1−16
Festo P.BE−CPX−FB23−EN en 0308NH
With the operating mode Remote Controller" both switches
of the 2−element DIL switch 4 must be set to OFF. 8 I/O bytes
are intended for communication between the field bus node
and an integrated FEC (in preparation).
Further information on the number of stations per slave can
be found in section 2.1.
Please note
Depending on the number of stations set per slave, subse
quent slave addresses are also assigned.
CC−Link slave addresses may only be assigned once per
field bus line.
Example: slave address = 2 / number of stations = 3
slave address = 3 / number of stations = 1
Address
Assignment
1
2
3
4
5
6
...
...
Station 1 / Slave 2
Station 2 / Slave 2
Station 3 / Slave 2
Station 1 / Slave 3
...
Tab.1/8:
Example of slave addresses and number of
stations (see also Fig.2/16)
Observe the general rules on addressing in the manual for
your CC−Link master.
Summary of Contents for CPX-FB23
