A. Technical appendix
A−6
Festo P.BE−CPX−CMA X−SYS−EN en 0908NH
A.2
Replacing components
When replacing components, observe the instructions in
Tab.A/5.
Replacement
Description
... of a CMAX or CPX terminal
·
Parameterisation / identification / adaptation:
A lot of acquired data depends on the individual components and
can therefore not be parameterised. Therefore, after exchanging,
complete commissioning is to always be carried out again.
·
Movement test:
The movement test can be skipped when the drive, displacement
encoder or VPWP are unchanged, as well as when there have
been no changes to the tubing connections.
... of drive, displacement
encoder or VPWP and
changes to the tubing con
nections
·
Parameterisation:
When identical components are replaced, the parameterisation
remains unchanged.
·
Movement test:
It is urgently recommended that the movement test be carried
out.
·
Identification / adaptation:
The acquired data depends on the individual components. There
fore, after exchanging, identification / complete commissioning is
to always be carried out again.
·
Zero points / position values / record list:
The absolute references can be parameterised automatically via
the bus master.
However, note that the reference system may change when the
drive or displacement encoder is replaced!
... other components
Electrically identical components can be replaced without further
changes.
Tab.A/5: Replacing components
Summary of Contents for CPX-CMAX-C1-1
