126
9 Levelling system operation
9.11 Working with the 3D slope sensor
The 3D slope sensor is not an additional sensor in the actual meaning
of the word.
The digital slope sensor already described above is used to register the
actual value of the tool slope. In contrast to the digital slope sensor,
when working with the 3D slope sensor the nominal value is not
entered manually but defined automatically by the 3D system
according to the specific position.
The user cannot adjust the nominal value in the automatic mode.
9.11.1 Installation and set-up
Commission the MOBA 3D system according to its operating
instructions.
A description of the installation, wiring and configuration of the system
components, ascertaining the vehicle dimensions and entering them in
the 3D software, calibration of the mast slope sensor and above all a
description of how the 3D software works goes beyond the scope of
these operating instructions.
Separate instructions for working with MOBA 3D are available from
your dealer.
9.11.2 Actual value reset
The actual value reset synchronises the measured value of the digital
slope sensor with the actual slope of the tool.
This synchronisation is necessary for example if the digital slope sensor
has not been installed absolutely parallel to the lower edge of the tool.
(see also chapter "9.1.2 Actual value reset")
