Farm King Model 1050, Operator And Parts Manual

Page: 82 / 174

80
Operation - 10" Backsaver Auger
Unloading Rear And Side Dump Units
Rear Dump Units
Figure 136
Move the hopper out at a 90° angle from the auger
[Figure 136] .
Move the rear dump unit into the unloading position at
the end of the hopper (Item 1) or on the tractor side of
the hopper (Item 2) [Figure 136] .
Position the gate of the rear dump unit over the
hopper (as close to the center of the hopper as
possible).
Stop the rear dump unit and engage the parking brake
(if equipped).
With tractor running at a low idle, engage the tractor
PTO slowly to start the auger. Increase engine RPM
(do not exceed 540 RPM PTO speed).
Slowly open the gate on the rear dump unit.
Adjust gate until the hopper augers and intake auger
can move grain to the main auger without overflowing
the hopper.
When the unit is empty, close the gate, disengage the
PTO and lower engine RPM speed.
Disengage the tractor hydraulics and exit the tractor.
B-0542
1
2
• Do NOT exceed 540 RPM PTO.
• Keep PTO shields and all guards in place.
• Keep away from moving parts.
• Keep bystanders away.