Farm King Model 1050, Operator And Parts Manual

Page: 45 / 174

43
Assembly - 10" Backsaver Auger
Figure 62
Locate two cable yoke brackets (Item 1) [Figure 62] .
Install the cable loop into the end of the cable yoke
bracket.
Install one 1/2” x 2” bolt (Item 2) through the
mounting bracket (Item 3) and cable yoke bracket.
Install one 1/2” lock nut (Item 4) [Figure 62] on the
bolt. Do not tighten at this time.
Align the end hole of the cable yoke bracket with the
mounting bracket (Item 3) [Figure 62] on the bottom
tube section (both sides).
Install one 1/2” x 2” bolt (Item 5) through the cable
yoke bracket and cable loop (1/2” cable). Install one
1/2” lock nut (Item 6) [Figure 62] . Do not tighten at
this time.
Repeat the above procedure for the remaining three
cables.
Tighten all 1/2” cable bolts at this time.
Figure 63
Raise input box end of tube approximately three feet
off the ground.
Locate one eyebolt (Item 1)
[Figure 63] .
Install the thimble (Item 2) [Figure 63] onto the
eyebolt (both sides).
Thread the cable through the eyebolt (both sides). Pull
cable as tight as possible.
Install the two 1/2” cable clamps (Item 3) [Figure 63]
onto the cable. Slide the first cable clamp (loop end)
as close to the thimble as possible and tighten (both
sides).
Slide the second cable clamp approximately 2 inches
(51 mm) from the end of the tail and tighten (both
sides).
Repeat the above procedure for the remaining three 1/
2” cables.
B-0653
1
2
3
4
5
6
B-0659
2
1
2
3
Always insert the tail of the cable into the clamp first
when forming a loop in a cable.