SAFETY
Page B-3
Repair and Service Manual
Read all of Section A and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
B
B
Fig. 1 Attach Accessory Wires to Battery Pack
Accessories connected to this vehicle that do not use
the accessory harness must be connected across the
entire 48 volt battery pack. This can be done by con-
necting to the two battery terminals shown in Figure 1.
This can be done by connecting to the two battery termi-
nals shown in the illustration.(Ref. Fig. 1) If the acces-
sory requires voltage other than 48 volts a DC to DC
converter must be used to change the voltage to the
amount required by the accessory. A DC to DC con-
verter is available through E-Z-GO Service Parts.
The Operational Performance Guarantee of 2 rounds
per day shall be void if non-factory accessories that use
more than 1 Amp/Hour of energy per round are installed
on the vehicle.
ATTACH NEGATIVE WIRE
FROM ACCESSORY TO
(-) BATTERY TERMINAL
ATTACH POWER WIRE
FROM ACCESSORY TO
(+) BATTERY TERMINAL