ELECTRICAL COMPONENTS & WIRING
Page K-5
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions and Warnings.
B
B
Fig. 11 Harness Routing & Pedal Connections
c) Connect the wires to the accelerator rotary position
sensor (5) and the throttle enable switch connector
(4).
d) Place pedal assembly in position on the floorboard
and secure with three Torx screws (6).
e) Connect the wires to the brake pedal rotary posi-
tion sensor (8) and the brake enable switch con-
nector (9).
f) Place pedal assembly in position on the floorboard
and secure with four socket head hex screws (10).
g) Route the remaining wires in the floorboard chan-
nel that runs up under the instrument panel.
h) Feed the connectors for the key switch, the
optional fuel gauge/state of charge meter and the
diagnostic plug through the opening in the cup
holder base (12). Place the diagnostic plug (13)
into the cup holder base and route the connectors
for the key switch (14) and the fuel gauge/state of
charge meter over the front splash shield.
Fig. 12 Cup Holder
i) Route the wires (14) for the key switch and the
optional fuel gauge/state of charge meter through
the guide (15) on the front splash shield and the
connectors for the key switch and the optional fuel
gauge/state of charge meter through the opening
(16) in the back of the instrument panel.
l.
Fig. 13 Front Splash Shield
j) Connect the wire harness to the key switch.
k) Route the two rear sections of the harness
between the rear body and the battery pack mak-
ing sure that the longer wires (21) are routed to the
passenger side.
l) Plug the connector (20) for the charger receptacle
into the connector on the main wiring harness.
