Profiles for PHOENIX MIG/MAG systems
Profiles for the CAN DeviceNet module
54
Item No.: 099-008225-EWM01
Actuation data
Byte
no.
Bit no.
Function
Description
1 3 WF switching (optional)
Bit allocation:
0
1
Switches between 2 wire drive units
WF case 1 is active
WF case 2 is active
1
4
Error reset
Acknowledgement signal for system error
1 5 User-defined
output
Bit allocation:
0
1
Switches the user-defined relay output on the bus
module
Relay not switched
Relay switched
1 6 Job
mode
Bit allocation:
0
1
Signal activates the JOB mode function
JOB mode switched off
JOB mode active
1 7 Welding
simulation
Bit allocation:
0
1
Activates the Simulate Welding function
Simulation active
Simulation off
2
0-3
Program number specification Select a program number in the range 0-15
2
7
Specification of master power
source with TANDEM
systems (optional)
Bit allocation:
0
1
Activates the master/slave power source in a
TANDEM system
System adopts slave function
System adopts master function
3
0-7
JOB number specification
Select a JOB number in the range
1-255
