Evoqua WALLACE & TIERNAN SFC, Original Instruction Manual

Page: 134 / 288

134
WT.050.590.000.DE.IM.0719
Installation
SFC
5.
5.3.2 Pour in the cell sand (only with DEPOLOX
®
5 and
DEPOLOX ® Pool)
Caution!
Before opening the cover on the pressurized version always first
release the pressure in the cell body with the drain screw.
1 Close the ball valve on the sample water inlet and outlet
(pressurized version).
2 On the non-pressurized version, remove the protection plugs
on the cell body cover of the 3-electrode cells.
On the pressurized version, unscrew the protection plugs on
the cell body cover of the 3-electrode cells.
3 Fill half a cap from the plastic bottle with cell sand and pour it
into the cell body (approx. 1/2 cm³ cell sand).
4 On the non-pressurized version, replace the protection plugs
on the cell body cover of the 3-electrode cells.
On the pressurized version, screw the protection plugs on the
cell body cover of the 3-electrode cells.
Please note
Make sure that the opening (especially the threads in the
pressurized version) is clean; rinse with water, if necessary.
5 Reopen the ball valve on the sample water inlet and outlet
(pressurized version).
Please note
The system must be recalibrated approx. 4 hours after each time
the cell sand is replaced.
The calibration must be checked after one day.