Evolis AV1H0000BD, Service Manual

Page: 54 / 293

Service Manual_AVA1_ENG-20220922_I 54
Error Code Item Description
39-XX Error Message Remove Card: fdr
Outline Card supply assembly card jam error
Detection Description The printer detected a card jam at the Card Sensor (Cleaning Assembly Inlet)
( SN24 ) and the Card Sensor (Cleaning Assembly Outlet) ( SN2 ).
Remedy [Related parts]
• Harnesses from the Card Sensor (Cleaning Assembly Inlet) ( SN24 ) to
the Main board
•
Harnesses from the Card Sensor (Cleaning Assembly Outlet) ( SN2 ) to
the Main board
•
Harnesses from the Card Supply Motor ( PM1 ) to the Main board
•
Card Sensor (Cleaning Assembly Inlet) ( SN24 )
•
Card Sensor (Cleaning Assembly Outlet) ( SN2 )
•
Card Supply Motor ( PM1 )
•
Main board
[Remedy]
1.
Check the card position at the jam error occurrence. If the card is
delivered to the cleaning roller, the Card Feed Motor (Reverse
Assembly) ( PM2 ) may indicate failure. Refer to error code 22-XX.
2. Check the reaction of the Card Sensor (Cleaning Assembly Inlet)
( SN24 ) and the Card Sensor (Cleaning Assembly Outlet) ( SN2 ) in the
sensor check mode (page 27 )
.
3.
Check the reaction of the Card Supply Motor ( PM1 ) in the action check
mode of the service mode (page 27 )
.
If it is operating properly, clean
the card supply roller.
4.
Check/replace the related harness/cable, connector and parts.
3A-XX Error Message Remove Card: fdr
Outline Card supply assembly card jam error
Detection Description The printer detected a card jam at the Card Sensor (Cleaning Assembly
Outlet) ( SN2 ).
Remedy [Related parts]
• Harnesses from the Card Sensor (Cleaning Assembly Outlet) ( SN2 ) to
the Main board
•
Harnesses from the Card Feed Motor (Reverse Assembly) ( PM2 ) to the
Main board
• Card Sensor (Cleaning Assembly Outlet) ( SN2 )
• Card Feed Motor (Reverse Assembly) ( PM2 )
• Main board
[Remedy]
1.
Check the reaction of the Card Sensor (Cleaning Assembly Outlet)
( SN2 ) in the sensor check mode
2.
Check the reaction of the Card Feed Motor (Reverse Assembly) ( PM2 )
in the action check mode of the service mode (page 27 )
.
If it is
operating properly, clean the cleaning roller and card feed roller.
3.
Check/replace the related harness/cable, connector and parts.
3B-XX Error Message Feeder Card Jam
Outline Card supply assembly card delay jam error
Detection Description The card did not reach the Card Sensor (Cleaning Assembly Inlet) ( SN24 ).
Remedy [Related parts]
•
Harnesses from the Card Sensor (Cleaning Assembly Inlet) ( SN24 ) to
the Main board
•
Harnesses from the Card Supply Motor ( PM1 ) to the Main board
•
Card Sensor (Cleaning Assembly Inlet) ( SN24 )
•
Card Supply Motor ( PM1 )
•
Main board
[Remedy]
1.
Check the reaction of the Card Sensor (Cleaning Assembly Inlet)
( SN24 ) in the sensor check mode (page 27 ) . Check the reaction of the
Card Supply Motor ( PM1 ) in the action check mode of the service
mode (page 27 ) . If it is operating properly, clean the card supply
roller.
2.
Check/replace the related harness/cable, connector and parts.