Evolis AV1H0000BD, Service Manual

Page: 45 / 293

Service Manual_AVA1_ENG-20220922_I 45
Error Code Item Description
1D-0A Error Message Invalid Film
Outline Transfer film use position error (non-detection)
Detection
Description
The printer could not detect the transfer film use position.
1D-0A Remedy [Related parts]
•
Transfer Film Cassette
•
Harnesses from the Film Beginning Sensor 1 ( SN12 ) to the Main board
•
Harnesses from the Film Beginning Sensor 2 ( SN13 ) to the Main board
•
Film Beginning Sensor 1 ( SN12 )
•
Film Beginning Sensor 2 ( SN13 )
•
Main board
[Remedy]
1. Check the following items of the transfer film cassette.
⋅
There is no damage in the transfer film cassette.
⋅
There is no breakage or improper winding of the transfer film.
⋅ It is not empty.
⋅
The transfer film is properly set.
2. Execute the sensor automatic adjustment in the sensor check mode
of the service mode (page 27 ).
3. Check/replace the related harness/cable, connector and parts.
Error Code Item Description
1E-05 Error Message Remove Film
Outline Transfer film installation detection error (during cleaning operation)
Detection Description The printer detected the installation error of the transfer film during cleaning
operation.
Remedy [Related parts]
• Transfer Film Cassette
•
Harnesses from the Film Feed Length Sensor (Supply Axis) ( SN15 ) to
the Main board
•
Harnesses from the Film Wind Up Motor ( DM3 ) to the Main board
• Film Feed Length Sensor (Supply Axis) ( SN15 )
• Film Wind Up Motor ( DM3 )
• Main board
[Remedy]
1. Check the following items of the transfer film cassette.
⋅
There is no damage in the transfer film cassette.
⋅
The transfer film is not set.
2. Check the reaction of the Film Feed Length Sensor (Supply Axis)
(SN15) in the sensor check mode (page 27 ).
3. Check/replace the related harness/cable, connector and parts.
20-XX Error Message Remove Card: flip
Outline Card supply assembly card jam error
Detection Description The printer detected a card jam at the Card Sensor (Cleaning Assembly Inlet)
( SN24 ).
Remedy [Related parts]
•
Harnesses from the Card Sensor (Cleaning Assembly Inlet) ( SN24 ) to the Main
board
•
Harnesses from the Card Supply Motor ( PM1 ) to the Main board
•
Card Sensor (Cleaning Assembly Inlet) ( SN24 )
•
Card Supply Motor ( PM1 )
•
Main board
[Remedy]
1. Check the card position at the jam error occurrence. If the card is delivered to
the cleaning roller, the Card Feed Motor (Reverse Assembly) ( PM2 ) may
indicate failure. Refer to error code 22-XX.
2. Check the reaction of the Card Sensor (Cleaning Assembly Inlet) ( SN24 ) in the
sensor check mode (
page 27
).
3. Check the reaction of the Card Supply Motor ( PM1 ) in the action check mode of
the service mode (
page 27
). If it is operating properly, clean the card supply
roller.
4. Check/replace the related harness/cable, connector and parts.