Evolis AV1H0000BD, Service Manual

Page: 94 / 293

Service Manual_AVA1_ENG-20220922_I 94
Revision Check
Revision Check >
Revision Overview Display of the revision of the printer configuration (8-digit)
Adj/Set/Ope
rate Method
N/A (Display only)
Rbn Back
Tension
Overview Set of the duty of the Ribbon Supply Motor (DM2) at the primary
transfer
Detail Set the duty of the Ribbon Supply Motor (DM2) at the primary
transfer.
Adj/Set/Ope
rate Method
1.
Select the setting value.
2.
Press the SET key, and then confirm the setting value.
Caution Do not change "REVSION 0 ".
Display/Adj/
Set Range
REVSION 0
REVSION 1
Default Value REVSION 0
Ribbn Tension Overview Set of the duty of the Ribbon Wind Up Motor (DM1) at the primary
transfer
Detail Set the duty of the Ribbon Wind Up Motor (DM1) at the primary
transfer. Set the value depending on the stripping mechanism of
the primary transferring.
•
REVSION 0: flat stripping shaft
•
REVSION 1: stepped stripping shaft
Adj/Set/Ope
rate Method
1.
Select the setting value.
2.
Press the SET key, and then confirm the setting value.
Display/Adj/
Set Range
REVSION 0
REVSION 1
Platen Nip Duty Overview Set the duty of the Platen Lift Motor (DM5)
Detail Set the duty of the Platen Lift Motor (DM5). Set the value depending
on the platen elevating mechanism of the Printhead.
•
0: if there is no cam follower bearing.
•
1: if there is a cam follower bearing.
Adj/Set/Ope
rate Method
1.
Select the setting value.
2.
Press the SET key, and then confirm the setting value.
Display/Adj/
Set Range
REVSION 0
REVSION 1
Thermister Overview Set of the thermistor configuration
Detail
Set the thermistor configuration. Set the value depending on the
presence of the Outer Air Thermistor (TM4).
•
0: if there is not the Outer Air Thermistor (TM4).
•
1: if there is the Outer Air Thermistor (TM4).
Adj/Set/Ope
rate Method
1.
Select the setting value.
2.
Press the SET key, and then confirm the setting value.
Display/Adj/
Set Range
REVSION 0
REVSION 1
Supplement/M
emo
When 0 is set, the printer operates with an ambient temperature
setting of 23 deg C.
Heat Roller Overview Set of the kind of the heat roller
Heat Roller
Detail Set the value depending on the heat roller.
•
0: initial version
•
1: version upgrade of revision 0
•
2: discontinuance of revision 1
Adj/Set/Ope
rate Method
1.
Select the setting value.
2.
Press the SET key, and then confirm the setting value.
Display/Adj/
Set Range REVSION 0
REVSION 1
REVSION 2