Epygi Quadro4Li, Administrator'S Manual

Page: 30 / 145

Quadro4Li Manual II: Administrator's Guide Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
29
Please Note: Installing new firmware will take about 15
minutes. During this time, Quadro, telephony and Internet
access will be disabled.
The firmware update will cause the loss of the following data:
•
All internally stored voice mails and custom voice
messages
Please Note: If you do not wish to lose your voice data, have
it downloaded from Configuration Management page prior to
starting the Firmware Update.
•
DHCP leases
•
Transfer statistics
•
Call statistics
Please Note: If you consider the Call Statistics entries in the
displayed tables to be important, it is recommended to
download them from the corresponding page prior to starting
the Firmware Update.
Fig. II-47: Firmware Update page 1
•
All pending events
•
User specific GUI states
The following main processes will be stopped during the firmware update and will be restarted after the installation is completed:
•
Voice Software
•
Network Time Protocol Daemon
•
Network Interface Statistic Daemon
•
Dynamic DNS Daemon
The Automatic Firmware Update link leads you to the page where the automatic update of the Quadro's firmware (software image) can be
configured.
Next will move you to the second page of Firmware Update where the image file should be selected.
Attention:
Pressing the Next button will stop some vital processes on the Quadro, therefore you will need to reboot your device manually even if you
have cancelled the firmware update procedure on the following steps.
The second page of Firmware update has a Browse button
used to browse the image file, and the Specify Image text field
that will display the selected image filename.
Pressing Save will start uploading the image file to the board
and the next page will display results and verification of the
image being burned.
Fig. II-48: Firmware Update page 2
This page displays non-editable information about the image
validity. The
Image Check field will display “invalid” if the image
does not correspond to the hardware version.
The Current Software Version field shows the old software
version. The New Software Version field shows the new
version of the software image.
This page needs to be confirmed in order to continue image
updating. If you are sure that the image version is appropriate
for your device press
Save .
Fig. II-49: Firmware Check page