Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
33
The
Start detecting WAN Protocol
button is used to initiate
WAN diagnostics that will detect the WAN IP configurations:
static or through DHCP and PPP servers. For static WAN IP
configuration, gateway availability is checked. When acting as a
client, DHCP and PPP servers' accessibilities are being verified.
The
Start Network Diagnostics
button is used to initiate
network diagnostics, i.e to check the WAN link and IP
configuration, to verify gateway, DNS primary and secondary (if
configured) servers' accessibilities.
The
Download system logs
button is used to download all logs
to the local PC as a *.tar archive file. Logs can be used by Epygi
Technical Support Office to determine the problem occurred on
your Quadro.
The
Reboot this Device
button is used to reboot the Quadro.
Please note that the session with the Quadro will be closed, i.e.
Quadro GUI should be newly opened and new login will be
required afterwards.
The
Start ISDN Diagnostics
button is used to initiate ISDN BRI
low level diagnostic. With these tests the ISDN physical link is
checked and the Frame Synchronization is verified.
The field below will display the diagnostics results and the
connectivity conditions. System should be reconfigured if
problems occur during the diagnostics.
Fig. II-56: System Diagnostic page
Show System Logs
link leads to the page where Quadro’s logs might be viewed, downloaded and the logging setting may be adjusted.
System Logs
The
System Logs
page is accessible by pressing the
Show System Logs
link on the
Diagnostics
page. This page is used to adjust where system
logging settings, view system logs directly in your browser or download them locally to your PC.
The
System Logs
page consists of three sub-pages.
The
System Logs Settings
page is used to adjust the system
logging settings and contains the following components.
•
The
Enable User Logging
checkbox is used to enable user
level logging. This logging contains brief information about
events on the Quadro.
•
The
Enable Developer Logging
checkbox is used to enable
developer high level logging. This logging contains detailed
information about events on the Quadro.
•
The
Archived Logging
checkbox is used to is used to keep
more logs on the Quadro. This option allows to collect more
system information in the log files and to keep them longer.
Attention:
This option requires quite sufficient resources on
the Quadro. It is recommended to use this option in urgent
cases only.
Fig. II-57: System Logs - System Logs Settings page
•
The
Mark all Logs
button is used to set a line marker in the logs. If you need to follow a certain piece of log, push this button to set a starting
mark in all logs and then perform the needed actions over the Quadro. When the actions are done, push this button again to set an ending mark
in all logs. This way you shall clearly see a piece of log between the starting and ending marks generated during the certain actions taken over
the Quadro. The
Comment
text field is used to insert some text information which will be displayed next to the marks inserted in the logs. This
comment may describe the problem captured in the following logs and may be useful for the Technical Support.
•
The
Download all Logs
button is used to download all logs to the local PC as a *.tar archive file. These logs can then be used by the Epygi
Technical Support Office to determine the problem that has occurred on your Quadro.
