Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
30
If you have confirmed the firmware version, a new page with
firmware update progress will be displayed next. There are no
functions available on this page, just information about the
firmware update procedure. At some point the connection with
the device is being lost and you need to wait until the firmware
will be burned on the Quadro.
You will not be automatically redirected to the Login page. To
access the Quadro’s Web GUI, you need to connect Quadro
again and login.
Attention:
After the firmware update, all IP phones attached to
the Quadro should be restarted.
Fig. II-50: Firmware Update page
Automatic Firmware Update
The
Automatic Firmware Update
page allows you to configure an automatic update of the Quadro’s firmware (software image) as it becomes
available on the server. When this service is enabled, on the configured day and time Quadro will automatically check for a new available firmware
on the server and will either notify the administrator or update the firmware right away, depending on the configured settings.
The server configuration can be done manually or through the DHCP server. In case of DHCP server replying configuration, the corresponding
adjustments should be done on the DHCP server to automatically point the Quadro to the destination where the firmware is stored.
Please Note:
Independent on the selected server type, there should be an “
auto-update
” folder in the root directory of the server. Quadro will check
for any new firmware in that specific folder only. Besides the firmware *.bin file, the “
auto-update
” folder should contain supplementary file(s) to point
to the correct firmware file.
The detailed instructions on the functionality of automatic firmware update as well as server configuration are described in the “
Automatic Firmware
Update”
document which you can find at the Epygi Web support portal.
This page consists of the following components:
The
Enable Automatically Firmware Update
checkbox selection enables the automatic firmware update service on the Quadro.
Attention:
When the older firmware is installed on the Quadro, the system configuration will be lost and the device will be factory reset.
The first manipulation buttons group on this page allows you to choose between the manually configured firmware server and the server defined by
the DHCP server.
•
Assign manually
– this selection is used to manually
configure the firmware server settings. The
Server Name
(the IP address or hostname), the
Server Port
and the
Update Method
should be defined. The
Update Method
drop down list provides a possibility to choose among
TFTP, FTP, HTTP or HTTPS methods. For some of these
selections, authentication
Username
and
Password
can
be entered.
•
Assign automatically via DHCP
- choose this selection if
the Quadro acts as a DHCP client in its WAN interface. In
this case the firmware server’s configuration will be
automatically obtained from the DHCP server. This
selection requires previous configuration on the firmware
server and will work only if the “
auto-update
” directory is
created on the TFTP server. The DHCP server should also
be configured to provide the "TFTP server name"
parameter (option 66) to the Quadro.
The second manipulation buttons group on this page allows you
to select the frequency of checking for a new update.
•
Check and notify
– choose this selection if you only wish
to be notified about the new available firmware on the
server. With this selection, on the indicated weekday and
time, on daily or weekly basis, the Quadro will check for a
new firmware available on the server.
The way of
notification is configured from the
page.
Fig. II-51
:
Upload Configuration page
