LS10-B Rev.6
v
Before Reading This Manual
This section describes what you should know before reading this manual.
Structure of Control System
The LS10-B series Manipulators can be used with the following combinations of Controllers
and software.
Controller
: RC90-B
Software
: EPSON RC+ 7.0 Ver.7.4.2 or later
Turning ON/OFF Controller
When you see the instruction “Turn ON/OFF the Controller” in this manual, be sure to turn
ON/OFF all the hardware components. For the Controller composition, refer to the table
above.
Shape of Motors
The shape of the motors used for the Manipulator that you are using may be different from
the shape of the motors described in this manual because of the specifications.
Setting by Using Software
This manual contains setting procedures by using software. They are marked with the
following icon.
Figures in this Manual
The figures of manipulators indicated in this manual are basically Standard-model
Manipulator. Unless special instruction is provided, the specifications of Standard-model
and Cleanroom-model are the same.
Pictures in this Manual
Pictures and illustrations of the manipulator in this manual may differ from using
manipulator depending on the shipment date and the specifications.
EPSON
RC+
Summary of Contents for LS10-B
