Setup & Operation 5. Motion Range
LS10-B Rev.6
45
5.1.3 Max. Pulse Range of Joint #3
The 0 (zero) pulse position of Joint #3 is the position where the shaft is at its upper limit.
The pulse value is always negative because Joint #3 always moves lower than the 0 pulse
position.
Upper limit: 0 pulse
Joint #3 Stroke
Lower Limit Pulse
LS10-B***S (Standard-model)
200 mm
−
270336
pulse
300 mm
−
405504
pulse
LS10-B***C (Cleanroom-model)
170 mm
−
229786
pulse
270 mm
−
364954
pulse
For the
Cleanroom-model, the motion range set with the Joint #3 mechanical stop cannot be
changed.
5.1.4 Max. Pulse Range of Joint #4
The 0 (zero) pulse position of Joint #4 is the position where the flat near the end of the shaft
faces toward the end of Arm #2. With the 0 pulse as a starting point, the counterclockwise
pulse value is defined as the positive (+) and the clockwise pulse value is defined as the
negative (
-
).
+X 0
±
215040 pulse
+Y
Clockwise (
-
value)
Counterclockwise (+value)
NOTE
Summary of Contents for LS10-B
