1 Safety instructions
Mycom S CPM 153
6
Hauser
1.4
Operational safety
#
Warning!
If the device is used for any application other than those described in these Operating
Instructions, it may lead to unsafe and improper functioning of the measuring system
and is therefore not permitted.
The instrument has been designed and tested according to the state of the art and left
the factory in perfect functioning order. The instrument meets all the prevailing
regulations and EC directives - see "Technical data".
However, always pay attention to the following points:
•
Measuring systems used in Ex areas have a separate document (XA 236C/07/en)
which forms a
component part
of these Operating Instructions. Always follow the
installation regulations and the - partly deviating - connection data of the Ex documen-
tation as well. You can find the following symbols on the front page of the additional
Ex documentation (according to approval and test centre
(
0
Europe,
2
USA,
1
Canada).
•
The measuring device complies with the general safety requirements in accordance
with EN 61010, the EMC requirements of EN 61326, and NAMUR Recommendation
NE 21, 1998.
•
The manufacturer reserves the right to change the technical data in line with technical
progress at any time. You can obtain information on the current version of these
Operating Instructions and possible additions from your E+H sales centre.
1.4.1
Fail-safety
This instrument has been checked for protection against electromagnetic interference
in industrial use according to applicable European standards. It is protected against
electromagnetic interference by the following design measures:
•
cable screening
•
interference suppression filter
•
interference suppression capacitors
#
Warning!
Protection against interference as specified above is valid only for an instrument
connected according to the instructions in these Operating Instructions.
1.5
Return
If the transmitter has to be repaired, please return it
cleaned
to the E+H sales centre
responsible. You can find the address on the last page of these instructions. For returns
please use the original packaging.
With the instrument, please enclose a completed copy of the "Declaration of
Contamination" form. You can find this at the end of these Operating Instructions.
