Emerson Daniel 3814, Installation Manual

Page: 67 / 110

Figure 3-12: Base Enclosure security seals
A. Transmitter Electronics Enclosure
B. Security wire seals
C. Transmitter Electronics endcap security latch
D. Base Enclosure
4. Cut wire ends to remove excess wire.
This completes Base Enclosure security seal installation procedure.
3.7.3 Transducer assembly security seal
Use the following instructions and Figure 3-13 to install the security seal wire on the
transducer assembly.
Procedure
1. For each Transducer Assembly, install a security seal wire into and through one of
the two holes of the Locking Ring bolt (Item C) and through one of the two holes in
the Transducer Retainer (Item D). Choose holes that minimize counterclockwise
rotation of the Locking Ring bolt and the Transducer Retainer when security wire is
taut (maximum wire diameter 0.06 inch; 1.5mm).
2. For each Transducer Assembly, insert a security seal wire into one of the two holes
in the transducer cable connector (Item F) and feed through one of the two holes in
the transducer cable nut (item E).
3. Adjust the security wire, removing all slack and thread into the lead seal.
4. Cut wire ends to remove excess wire.
Installation manual Electrical Installation
3-9000-760 May 2019
Installation manual 67