Emerson Daniel 3814, Installation Manual

Page: 41 / 110

Figure 2-8: 90 Degree angle between slings
9. NEVER allow the slings to contact the electronics enclosure. Damage to the
enclosure may occur. Use a spreader bar with the slings to prevent contact with the
electronics enclosure and the base enclosure (see
Figure 2-10 ). If the slings do come
in contact with the electronic enclosure then remove the two bolts holding the
enclosure to its base and temporarily remove the head from the meter during the
lifting operation. You will need to unplug the cable from J3 on the Acquisition
Module. Two screws hold this cable in place. Once the lifting operation is complete,
reattach and secure the electronics cable to J3 on the Acquisition Module, return
the electronics enclosure to its original position, replace the bolts, and secure the
enclosure in place. Lifting the meter with the upper enclosure installed but without
the bolts installed, may cause the electronics to fall and cause personal injury or
equipment damage.
Installation manual Mechanical Installation
3-9000-760 May 2019
Installation manual 41