Emerson Daniel 3814, Installation Manual

Page: 45 / 110

Figure 2-10: Correct sling attachment
4. Visually inspect the slings prior to use for any signs of abrasion or other damage.
Refer to the sling manufacturer's procedures for proper inspection of the particular
sling you are using.
5. Only use slings with ratings that exceed the weight to be lifted. Reference your
company's standards for safety factors that must be included when calculating the
load rating.
6. NEVER allow the slings to contact the electronics enclosure or the transducer
cabling. Damage to the meter may occur. If the slings do come in contact with the
electronics enclosure, then remove the two bolts holding the enclosure to its base
and temporarily remove the head from the meter during the lifting operation
(remove the two bolts holding the enclosure to its base and unplug the cable from
the Acquisition Module. Two screws hold this cable in place.) Use a spreader-bar on
the sling to prevent contact with the electronics. Once the lifting operation is
complete, reattach and secure the electronics cable to J3 on the Acquisition
Module, return the electronics enclosure to its original position, replace the bolts,
and secure the enclosure in place. Lifting the meter with the upper enclosure
Installation manual Mechanical Installation
3-9000-760 May 2019
Installation manual 45