Manufacturer: PPHU
EKOLOT
Type: KR-030 TOPAZ
Handling, Maintenance and Periodic Inspections
Manual
Issue: 1
Rev. N
o
:
Date: July 2010
Date:
Page
93
10. Perform operation test of the system:
- The throttle levers should move smoothly, without unnecessary play.
- There should not be excessive friction in the Bowden cables.
- The cables should not come loose during the operation of levers.
11. Secure the cables tips with heat shrink sleeves (Pic. 9.4.2.10)
12. Put the conduits J.12.450.00.03 (Pic. 9.4.2.7 white arrow), into the
bracket seats J.12.423.00.03 (Pic. 9.4.2.4), insert the cable
J.12.450.00.03 and fix as shown in the Pic. 9.4.2.7.
13. Tips of the cable J.12.450.00.03 should be pulled through the
rubber eyes in the former and the firewall to the engine compartment
(Pic. 9.4.2.7 red arrow)
14. Install the cover J.12.400.02.03 of the intermediate bracket (Pic.
9.4.2.6).
9.4.2.5 Adjustment of the intermediate bracket clamp J.12.422.00.03
(Pic. 9.4.2.4). After connecting the cables J.12.450.00.03 to the
carburetors levers and adjustment of the engine control.
The clamp of the bracket is adjusted with the nut „N” in the Pic. 9.4.2.3.
The nut should be tightened in such way, the carburetors throttles springs do
not cause self-acting reversion of the levers, and at the same time the
operation of the levers was smooth.
The nut's thread should be covered with LOCTITE 262.
Perform the check as described in procedure 9.4.2.4, point 10.
Pic. 9.4.2.10
