Manufacturer: PPHU
EKOLOT
Type: KR-030 TOPAZ
Handling, maintenance and periodic inspections
manual
Issue: 1
Rev. N
o
:
Date: July 2010
Date:
Page
160
a. Remove the oil hose from the oil tank barb fitting (see point
10 in the procedure 9.4.6)
b. Remove the oil hose from the oil cooler barb fitting (see point
2)
c. Remove the steel clamps and remove the rubber hose
d. Install new rubber hose on the barb fittings and secure with
steel clamps W1 18-20
e. Install the oil hose on the oil cooler barb fitting (see point 2)
f. Install the oil hose to the oil tank barb fitting (see point 8 in the
procedure 9.4.7)
−
Oil hose J.15.254.00.00
a. Remove the breather pipe from the oil tank (see point 10 in
the procedure 9.4.6)
b. Remove the oil hoseJ.15.254.00.00 from the oil tank (see
point 10 in the procedure 9.4.6)
c. Drain oil from the engine (see point 11 in the procedure 9.4.6)
d. Disconnect the oil hose from the oil sump at the bottom of the
engine block
e. Loosen the clamps on the hose and remove the rubber hose
f. Put a new rubber hose and secure with the clamp W1 18-20;
put the other clamp on the other tip of the hose
g. Connect the oil hose J.15.254.00.00 to the oil tank (see point
8 in the procedure 9.4.7)
h. Connect the oil hose J.15.254.00.00 to the oil sump barbed
fitting at the bottom of the engine
i. Connect the breather pipe to the oil tank and secure with the
clamp W1 13-15 (see point 8 of the procedure 9.4.7)
j. Fill the system with engine oil according to Operation Manual
of the Rotax Engine
J.15.254.00.00
Hose W1
18-20
Barb fitting
Rotax
Pic. 9.4.4.9