Edge-Core ECS4660-28F, Management Manual, Page: 987 / 2020

C
HAPTER
24
| System Management Commands
Synchronous Ethernet
– 987 –
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆ Use this command to configure the clock source according to the SSM
Quality Level (QL), port priority (as defined under the synce ssm
ethernet command), and port number.
If the SSM QL received on more than one port is the same, the clock
source port is selected according to priority.
If SSM QL and priority are the same on more than one port, the lower
port number be chosen as the clock source port.
◆ If the clock source port has been manually configured (i.e., the active
clock source is locked), SSM clock source selection will not function.
E
XAMPLE
Console(config)#synce ssm ethernet 1/25
Console(config)#synce ssm ethernet 1/26
Console(config)#synce ssm ethernet 1/27
Console(config)#synce ssm ethernet 1/28
Console(config)#
show synce
This command shows SyncE status, selection mode, clock source status,
and SSM status.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#show synce
SyncE Status:
Port Status Clock Source
--------- -------- ------------
Eth 1/25 Enabled No
Eth 1/26 Enabled No
Eth 1/27 Enabled No
Eth 1/28 Enabled No
SyncE Clock Source Selection Mode: SSM
SyncE Active Clock Source Locked: No
SyncE Clock Source Status:
Port Priority Active Clock Source Clock Status
--------- -------- ------------------- ------------
Eth 1/25 1 Yes Good
Eth 1/26 2 No Bad
SyncE SSM Status:
Port Status Pri Tx SSM Rx SSM
--------- -------- --- ------- -------
Eth 1/25 Enabled 0 QL_NONE QL_EEC1
Eth 1/26 Enabled 0 QL-DNU QL_EEC1
Eth 1/27 Enabled 0 QL_NONE QL_NONE
Eth 1/28 Enabled 0 QL_NONE QL_NONE