Edge-Core ECS4660-28F, Management Manual, Page: 1543 / 2020

C
HAPTER
44
| LLDP Commands
– 1543 –
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive
mode on the specified port. Use the no form to disable this feature.
S
YNTAX
lldp admin-status { rx-only | tx-only | tx-rx }
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
D
EFAULT
S
ETTING
tx-rx
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp basic-tlv
management-ip-
address
This command configures an LLDP-enabled port to advertise the
management address for this device. Use the no form to disable this
feature.
S
YNTAX
[ no ] lldp basic-tlv management-ip-address
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆
The management address protocol packet includes the IPv4 address of
the switch. If no management address is available, the address should
be the MAC address for the CPU or for the port sending this
advertisement.
◆
The management address TLV may also include information about the
specific interface associated with this address, and an object identifier
indicating the type of hardware component or protocol entity associated
with this address. The interface number and OID are included to assist
SNMP applications to perform network discovery by indicating