Edge-Core ECS4660-28F, Management Manual, Page: 1002 / 2020

C
HAPTER
25
| SNMP Commands
SNMP Target Host Commands
– 1002 –
page 480 for further information about these authentication and
encryption options.
port - Host UDP port to use. (Range: 1-65535; Default: 162)
D
EFAULT
S
ETTING
Host Address: None
Notification Type: Traps
SNMP Version: 1
UDP Port: 162
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
If you do not enter an snmp-server host command, no notifications
are sent. In order to configure the switch to send SNMP notifications,
you must enter at least one snmp-server host command. In order to
enable multiple hosts, you must issue a separate snmp-server host
command for each host.
◆
The snmp-server host command is used in conjunction with the
snmp-server enable traps command. Use the snmp-server enable traps
command to enable the sending of traps or informs and to specify
which SNMP notifications are sent globally. For a host to receive
notifications, at least one snmp-server enable traps command and the
snmp-server host command for that host must be enabled.
◆
Some notification types cannot be controlled with the snmp-server
enable traps command. For example, some notification types are
always enabled.
◆
Notifications are issued by the switch as trap messages by default. The
recipient of a trap message does not send a response to the switch.
Traps are therefore not as reliable as inform messages, which include a
request for acknowledgement of receipt. Informs can be used to ensure
that critical information is received by the host. However, note that
informs consume more system resources because they must be kept in
memory until a response is received. Informs also add to network
traffic. You should consider these effects when deciding whether to
issue notifications as traps or informs.
To send an inform to a SNMPv2c host, complete these steps:
1.
Enable the SNMP agent ( page 997 ).
2.
Create a view with the required notification messages ( page 1008 ).
3.
Create a group that includes the required notify view ( page 1006 ).
4.
Allow the switch to send SNMP traps; i.e., notifications ( page 1000 ).
5.
Specify the target host that will receive inform messages with the
snmp-server host command as described in this section.