Edge-Core ECS4660-28F, Management Manual, Page: 1951 / 2020

C
HAPTER
52
| Multicast Routing Commands
PIM Multicast Routing
– 1951 –
PIM6 Shared Mode Commands
router pim6
This command enables IPv6 Protocol-Independent Multicast routing
globally on the router. Use the no form to disable PIM multicast routing.
S
YNTAX
[ no ] router pim6
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
This command enables PIM-DM and PIM-SM for IPv6 globally for the
router. You also need to enable PIM-DM and PIM-SM for each interface
that will support multicast routing using the ipv6 pim command, and
make any changes necessary to the multicast protocol parameters.
◆
To use PIMv6, IPv6 multicast routing must be enabled on the switch
using the ipv6 multicast-routing command.
◆
To use IPv6 multicast routing, MLD proxy cannot be enabled on any
interface of the device (see the ipv6 mld proxy command).
E
XAMPLE
Console(config)#router pim6
Console(config)#
ipv6 pim
This command enables IPv6 PIM-DM or PIM-SM on the specified interface.
Use the no form to disable IPv6 PIM-DM or PIM-SM on this interface.
S
YNTAX
[ no ] ipv6 pim { dense-mode | sparse-mode }
dense-mode - Enables PIM Dense Mode.
sparse-mode - Enables PIM Sparse Mode.
show ipv6 pim bsr-router Displays information about the BSR PE
show ipv6 pim
rp mapping
Displays active RPs and associated multicast routing
entries
PE
show ipv6 pim rp-hash Displays the RP used for the specified multicast group PE
Table 288: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function Mode