Edge-Core ECS4660-28F, Management Manual, Page: 1297 / 2020

C
HAPTER
38
| Spanning Tree Commands
– 1297 –
C
OMMAND
U
SAGE
◆
This command defines the priority for the use of an interface in the
multiple spanning-tree. If the path cost for all interfaces on a switch are
the same, the interface with the highest priority (that is, lowest value)
will be configured as an active link in the spanning tree.
◆
Where more than one interface is assigned the highest priority, the
interface with lowest numeric identifier will be enabled.
E
XAMPLE
Console(config)#interface Ethernet 1/5
Console(config-if)#spanning-tree mst 1 port-priority 0
Console(config-if)#
R
ELATED
C
OMMANDS
spanning-tree mst cost (1295)
spanning-tree
port-bpdu-flooding
This command floods BPDUs to other ports when spanning tree is disabled
globally or disabled on a specific port. Use the no form to restore the
default setting.
S
YNTAX
[ no ] spanning-tree port-bpdu-flooding
D
EFAULT
S
ETTING
Enabled
C
OMMAND
M
ODE
Interface Configuration (Ethernet, Port Channel)
C
OMMAND
U
SAGE
◆ When enabled, BPDUs are flooded to all other ports on the switch or to
all other ports within the receiving port’s native VLAN as specified by
the spanning-tree system-bpdu-flooding command.
◆ The spanning-tree system-bpdu-flooding command has no effect if
BPDU flooding is disabled on a port by the spanning-tree port-bpdu-
flooding command.
E
XAMPLE
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree port-bpdu-flooding
Console(config-if)#