Edge-Core ECS4660-28F, Management Manual, Page: 941 / 2020

C
HAPTER
24
| System Management Commands
SMTP Alerts
– 941 –
logging sendmail
host
This command specifies SMTP servers that will be sent alert messages. Use
the no form to remove an SMTP server.
S
YNTAX
[ no ] logging sendmail host ip-address
ip-address - IPv4 or IPv6 address of an SMTP server that will be
sent alert messages for event handling.
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
You can specify up to three SMTP servers for event handing. However,
you must enter a separate command to specify each server.
◆
To send email alerts, the switch first opens a connection, sends all the
email alerts waiting in the queue one by one, and finally closes the
connection.
◆
To open a connection, the switch first selects the server that
successfully sent mail during the last connection, or the first server
configured by this command. If it fails to send mail, the switch selects
the next server in the list and tries to send mail again. If it still fails, the
system will repeat the process at a periodic interval. (A trap will be
triggered if the switch cannot successfully open a connection.)
E
XAMPLE
Console(config)#logging sendmail host 192.168.1.19
Console(config)#
logging sendmail
level
This command sets the severity threshold used to trigger alert messages.
Use the no form to restore the default setting.
S
YNTAX
logging sendmail level level
no logging sendmail level
level - One of the system message levels ( page 934 ). Messages
sent include the selected level down to level 0. (Range: 0-7;
Default: 7)
D
EFAULT
S
ETTING
Level 7