Edge-Core ECS4660-28F, Management Manual, Page: 572 / 2020

C
HAPTER
14
| Basic Administration Protocols
Connectivity Fault Management
– 572 –
W
EB
I
NTERFACE
To transmit loopback messages:
1.
Click Administration, CFM.
2.
Select Transmit Loopback from the Step list.
3.
Select an entry from MD Index and MA Index.
4.
Specify the source MEP, the target MEP using either its MEP identifier or
MAC address, set the number of times the loopback message is to be
sent.
5.
Click Apply.
Figure 314: Transmitting Loopback Messages
T
RANSMITTING
D
ELAY
-M
EASURE
R
EQUESTS
Use the Administration > CFM (Transmit Delay Measure) page to send
periodic delay-measure requests to a specified MEP within a maintenance
association.
CLI R
EFERENCES
◆
"ethernet cfm delay-measure two-way" on page 1600
C
OMMAND
U
SAGE
◆ Delay measurement can be used to measure frame delay and frame
delay variation between MEPs.
◆ A local MEP must be configured for the same MA before you can use
this function.
◆ If a MEP is enabled to generate frames with delay measurement (DM)
information, it periodically sends DM frames to its peer MEP in the same
MA., and expects to receive DM frames back from it.