Edge-Core ECS4660-28F, Management Manual, Page: 1655 / 2020

C
HAPTER
49
| IP Interface Commands
IPv4 Interface
– 1655 –
page 1616 ). If necessary, local devices can also be specified in the DNS
static host table (see page 1618 ).
E
XAMPLE
Console#ping 10.1.0.9
Type ESC to abort.
PING to 10.1.0.9, by 5 32-byte payload ICMP packets, timeout is 5 seconds
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 10 ms
response time: 0 ms
Ping statistics for 10.1.0.9:
5 packets transmitted, 5 packets received (100%), 0 packets lost (0%)
Approximate round trip times:
Minimum = 0 ms, Maximum = 10 ms, Average = 8 ms
Console#
R
ELATED
C
OMMANDS
interface (1188)
ARP C
ONFIGURATION
This section describes commands used to configure the Address Resolution
Protocol (ARP) on the switch.
arp
This command adds a static entry in the Address Resolution Protocol (ARP)
cache. Use the no form to remove an entry from the cache.
S
YNTAX
arp ip-address hardware-address
no arp ip-address
ip-address - IP address to map to a specified hardware address.
hardware-address - Hardware address to map to a specified IP
address. (The format for this address is xx-xx-xx-xx-xx-xx.)
D
EFAULT
S
ETTING
No default entries
Table 236: Address Resolution Protocol Commands
Command Function Mode
arp Adds a static entry in the ARP cache GC
arp timeout Sets the time a dynamic entry remains in the ARP
cache
GC
ip proxy-arp Enables proxy ARP service IC
clear arp-cache Deletes all dynamic entries from the ARP cache PE
show arp Displays entries in the ARP cache NE, PE