3 Installation
3.4 Power bus
Rapid Link 5 · RAMO5 · RASP5
05/20 MN034004EN
www.eaton.com
93
3.4.1.3 Installing the end piece
▶
First slide the lower (shorter) part of the RA-C1-END1 ribbon cable end
piece onto the prepared flexible busbar.
▶
Slot the individual conductors into the insulation channels in the ribbon
cable end piece as far as they will go.
▶
Join the upper and lower sections using the two clamping screws.
Installed correctly, the flexible busbar offers degree of protection IP65.
Figure 52:
RA-C1-END1 ribbon cable end piece
3.4.1.4 Flexible busbar junction connections
The supply and outgoer modules can be installed at any point along the flexi-
ble busbar without interrupting the busbar’s conductors. The connection is
made with contact screws.
Figure 53:
Pin assignment of the
Flexible busbar junction
RA-C1-PLF1
Pin
Function
Wire number
(7 x 4 mm
2
)
1
L1
1
2
L2
2
3
L3
3
4
N
4
5
+24 V
1)
5
6
0 V
1)
6
PE
PE
yellow/green
1) Not used on RAMO5 and RASP5.
L2 L3
N L1 PE