Eaton IQ 250, User & Installation Manual

Page: 91 / 142

Chapter 8:
IQ 250/260 Meter Programming the IQ 250/260
www.eaton.com
IB02601006E
8-27
Poll Limits (IQ 260 Only)
Click Real-Time Poll>Power Quality and Alarms>Limits . You will see the screen shown below.
This screen shows the current status of any Limits programmed in the Device Profile .
NOTE : See instructions for configuring Limits, earlier in this chapter.
1. The displayed fields are:
• Limit ID – the identification of the limit.
• Label - the item the Limit is set for.
• Value – the current reading for this item.
• Status/Limit1/Limit2 – whether the current reading is “In” or “Out” for the Above (Limit 1) and Below (Limit 2)
Setpoints.
• Limit 1/Setting/Point/Hysteresis – Above: the point above which the reading goes out of limit (Setpoint) and the
point at which it returns to within limit (Hysteresis).
• Limit 2/Setting/Point/Hysteresis – Below: the point below which the reading goes out of limit (Setpoint) and the
point at which it returns to within limit (Hysteresis).
2. Click Print to print the screen.
3. Click OK to close the screen.