4 Commissioning
4.9 PROFIdrive profile
DX-NET-PROFINET2-2
01/22 MN040062EN
www.eaton.com
49
Table 17:
Control word 1 – PROFIdrive profile
Byte
Bit
Designation
Meaning
1
0
Jog 1
Setpoint 1
If this bit and byte 1 bit 0 OnOff is activated after byte 0 bit 2
Ctl_PLC, byte 1 bit 1 Off2, byte 1 bit 2 Off3, byte 1 bit 3 EN_OP have
been activated, the variable frequency drive/variable speed starter
starts up with fixed frequency 1 forward.
1
Jog 2
Setpoint 2
If this bit and byte 1 bit 0 OnOff is activated after byte 0 bit 2
Ctl_PLC, byte 1 bit 1 Off2, byte 1 bit 2 Off3, byte 1 bit 3 EN_OP have
been activated, the variable frequency drive/variable speed starter
starts up with fixed frequency 2 forward.
2
Ctl_PLC
The PLC assumes control (Control by PLC).
0: no control via PLC
1: Control via PLC
With a value of 0, the PLC does not control the variable frequency drive.
With a value of 1, the controller assumes control of the variable
frequency drive/variable speed starter. Until then, no commands that
the variable frequency drive/variable speed starter receives from the
PLC are accepted.
3
f-Source
Setpoint source
The source for the setpoint can be defined in binary code.
4
5
Remote Output 0
Relay output (P-18 =12)
0: Do not activate output
1: Activate output
To use bit 6, P-18 must be set to 12.
Only then can the relay be activated remotely.
6
2nd ramp
Moves 2nd Ramp
0: 1st ramp active (P-03)
1: 2nd ramp active (P-24)
The device starts up with the ramp set in parameter P-24 if bit 6 is set
to 1.
7
ExtFault
External Fault
0: no external fault
1: external fault
If the bit is set, the variable frequency drive/variable speed starter stops
with a selected PNU 840.29952 function. The behavior corresponds to a
transition of 1
→
0 of the enable signal with the di
ff
erence that the vari-
able frequency drive goes into the Error status.
The external fault can be reset just like any other fault (with Fault
acknowledge (bit 7) or by switching the supply voltage off and on).
Bit 4
Bit 5
Setpoint source
0
0
Network speed
1
0
Analog input
0
1
f-fix3
1
1
f-fix4
