Duplo DP-S Series, Service Manual

Page: 146 / 298

145
c
Paper Feed Section
chap.4
(2) Adjusting the Elevator Top Limit Sensor
¡
For description of operation .
Adjustment procedure
1.
Insert a 1mm thick strip of material between the
paper feed roller and the paper feed inlet.
2.
Loosen the 2 screws indicated, then adjust the
sensor's position so that the bottom surface of
the paper feed shaft lever is at the center of the
sensor .
For adjustment, remove the
auxiliary paper separator unit.
3.
After adjustment, tighten the screws.
IMPORTANT :
\
See page 65
NOTE :
Screws
Elevator top limit
sensor
Paper feed shaft lever
1mm thick strip
R8S04019
c
Paper Feed Section
(1) Adjusting the Paper Separator Unit Clearance
¡
For description of operation .
Adjustment procedure
¡
When the paper separator unit is installed, use
the adjustment bolt to adjust the unit so that it
moves in direction
q q
without sticking, and
moves smoothly in direction
w w
. Tighten the
bolt's nut to fix the unit in the adjusted position.
\
See page 61
NOTE :
Paper separator unit
R8S04018
q q
w w
Nut