DTM Print LX610e, Color Label Printer

Page: 44 / 114

44 |
General Settings
3G1. Multiple Printer Support.
You can install multiple printers to the same computer and use them simultaneously. To do so you will need
to change the USB serial number identifier of one of the two printers, two of three printers, three of four
printers etc. To change serial numbers:
1. Connect each new printer one at a time. The current USB Serial Number will be displayed.
2. Click Generate. It will find the next available USB Serial Number based on the currently connected
printers. For the first one it should set it to 2 and for the next printer 3 and so on.
3. Click Set. You will hear the printer reset and the settings window will turn gray. After it resets you
will be able to see the settings window again. Keep the printer connected.
4. Now you can connect the next printer. Windows will automatically install a new driver for that new
printer and name it Color Label 610 (Copy 1). You can rename it later by editing the printer
properties in the Windows printer list.
5. You will now see a second printer appear in the left column – Color Label 610 (Copy 1). Click on it to
display information about this printer. If this is the last printer, you will connect you are done. If you
wish to connect additional printers follow through steps 2-4.
Restore Factory Defaults.
This will set all Print alignment and other calibration settings back to factory
defaults.
Cartridge Settings.
Here you can adjust the frequency of certain maintenance operations. Increasing the
value of “Seconds between Maintenance Spits” will decrease ink usage but could also cause poor quality
printing.
Increasing or Pages between Maintenance Wipes will speed up printing but could also cause poor quality
printing.
Check the Suppress Alignment message to prevent the window from appearing which prompts you to
align the cartridge every time a new cartridge is installed. Skipping the alignment is faster but can result in
poor print quality.