DTM Print LX610e, Color Label Printer

Page: 15 / 114

| 15
Max Min
Label width 127mm (5”) 13mm (0.5”)
Liner/media width 130.17mm (5.125”) 50.8mm (2”)
Label height/length 305mm (12”) 13mm (0.5”)
Gap between labels 253mm (10”) 2.5mm (0.10”)
Width of through-hole 12.65mm (0.5”) 6.325mm (0.25”)
Gap Sensor Adjustment
Range (from left edge)
52mm (2.05”) 10.16mm (0.40”)
Reflective/Black Mark Width* N/A 2.54mm (0.1”)
Max Outer Diameter (OD) 152.4mm(6.0”) N/A
Inner Core Diameter (ID) 76.2mm (3.0”) 76.2mm (3.0”)
Recommended Total Thickness
(Liner + Label)**
10 mil (.0010”)
Distance from edge of media to
edge of label
Printer assumes 2mm (1/16”) gap. However, this is adjustable
via the left margin offset.
* The Reflective/Black Mark should be opaque to infrared light. The mark should be between the labels. The
end of the mark should correspond with the beginning of the label.
** This is the recommended maximum. There are two factors that determine whether the printer will accept
any particular stock thickness.
1. The ability for the printer to pull the paper through the print area.
2. The ability for the sensor to read through the backing if the sensor is set to die-cut.
If you are printing in continuous or reflective label sensing mode number 2 does not apply. The fact that the
printer must read through the backing in die-cut mode will limit the thickness much more than the
printer’s ability to pull the paper through the print area. However, if you adjust opacity level of the liner
enough to allow the label to be seen by the stock sensor, the thickness will only be limited by the printer’s
ability to pull it through the printer area. For these reasons the weight or thickness of the liner is a variable
that cannot easily be defined. Primera recommends and uses 40# liner with all Pre Die-Cut label stock.
It is important to test all label stock with the intended printer before ordering large quantities!