| 29
2G Adjusting the Gap Sensor Position (Pre Die-Cut Labels Only)
If you are using label stock other than standard square / rectangular die-cut labels such as circular die-cut
labels or through-hole stock use the instructions below to adjust the position of the label stock gap sensor.
The sensor can be adjusted using the slide bar on the back of the printer. Below the slide bar is a
measurement which represents the distance between the edge of the label stock and the sensor. Measure
the distance from the edge of the label stock to the correct position on the stock. Set the sensor so the side
of the slide bar lines up to this measurement. See dashed line in the illustration below.
Important Note:
You must adjust the stock
sensor before loading nonstandard label
stock.
Circular Labels
If you are using Circular Labels you must adjust the stock sensor to correspond with the very top of the
label where the circles are closest together. If the sensor is too far to the right or the left the printer will still
sense the label but the image may be offset downward because the printer will start printing at the wrong
position. If you are using stock that has multiple labels across, make sure the sensor corresponds to a place
on the stock that has a label and not a vertical gap Important Note: You must adjust the stock sensor before
loading nonstandard label stock.31The sensor can only be moved a maximum of 2 inches from the left side
of the printable area. This means that the maximum diameter circular label that can be printed is 4 inches.
Summary of Contents for LX610e
Page 71: ... 71 5 Center the image horizontally and vertically to the Page ...
Page 88: ...88 1 Choose Start a new BarTender document ...
Page 89: ... 89 2 Select Blank Template Click Next 3 Select Color Label 610e Click Next ...
Page 109: ... 109 4 Prepare items needed for procedure 5 Soak the paper towels in water for 5 seconds ...
