85
Note
You must wait to delete the Controller from OnGuard until after it goes offline in Alarm
Monitoring. Failure to wait will result in a deep reset being sent to the Controller.
5 Add a new Controller in the Readers and Doors module, and assign it to the desired
Wi-Q Gateway (Access Panel dropdown list).
6 Wait for the changes to be communicated to the system hardware, and then check that
the Segment Tree reflects your update.
Moving a Wi-Q Gateway to a Different Segment
If you need to move a Wi-Q Gateway to a different Segment, perform the following steps
in System Administration:
1 Make sure that you have segmentation enabled in (Administration > Segments >
Segment Options).
2 Add additional segments as needed. See the System Administration User Guide for
more information on adding segments.
3 In the Access Panels module, navigate to the Wi-Q Gateway that must be relocated.
Click Modify.
4 Uncheck the Online checkbox next to the Name field.
5 Press OK and wait for the Wi-Q Gateway to go offline in Alarm Monitoring.
6 Once the Wi-Q Gateway is offline, click Modify on the Wi-Q Gateway again.
Summary of Contents for BEST Wi-Q ONGUARD
