17
Develop a Site Plan (Task 1)
Before installing Wi-Q Gateways, it is a good idea to develop a general plan for the
segment. This plan will guide you in deciding where to install the Wi-Q Gateways. You must
consider the following:
Transmit range from Wi-Q Gateway to controller varies based on building construction. Site
characteristics such as reinforced concrete walls could interfere or weaken the signal; open
spaces and low interference can increase signal strength.
shows a typical site configuration. The Host (A) is located in Building 1. The
Building 1 Wi-Q Gateway (B) is located near the electrical panel in the communications/
electronics room.
The Building 2 Wi-Q Gateway (C) is positioned next to the electrical panel. With 48 rooms
in this three-story dorm, front and rear access doors and access to the elevator on three
floors, this gateway provides coverage to 53 controllers. Its range extends to all three
floors of the building, and will also cover the pedestrian access, and elevator of the Parking
Garage.
The Parking Garage Wi-Q Gateway (D) is positioned to cover the pedestrian door near
the dorm and the stairway and elevator doors. Its range also extends to the entrance of
Buildings 1 and 2.
Summary of Contents for BEST Wi-Q ONGUARD
