Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
BEST
a Product Group of dormakaba USA Inc.
Installing the trim
8
14
Install bottom cover
(inside escutcheon)
1 Position the battery wires above the side tabs and
against the side of the fire plate, as shown in
Figure 13.
2
Optional for Thumb Turn option only:
Make sure
that the Thumb Turn is in the upright position, as
shown in Figure 13.
3
Making sure that the cover does not pinch the
wires
, guide the bottom cover over the chassis onto
the fire plate.
Note:
Phillips Type 2 and T20 Torx options are avail-
able for the cover mounting screws.
Inside of door
Figure 13 Installing the bottom cover
Bottom
cover
Cover
screws
Battery wires
Thumb turn
(optional)
Antenna wire
Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
BEST
a Product Group of dormakaba USA Inc.
7
Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
Installing the trim
13
Connect wire harnesses
1 From the inside of the door, make the following
2 Insert the plastic wire tie through the mounting clip
and secure the wires as shown in Figure 12.
Note:
It is physically possible to connect the key over-
ride sensor connector from the mortise case to the bat-
tery connector from the wire harness. To avoid this
mistake, connect only the connectors with matching
wire colors.
Caution: When making the motor connection
and sensor connections, make sure:
◆
there are no loose wire connections where the
wires are inserted into the connectors
◆
the connectors are firmly mated
connections:
Wire connection Colors
No. of
wires
No. of
pins
Motor
Yellow-gray
2
2
Gray
2
3
Blue
2
3
Orange-brown
2
3
Key override sensor
Deadbolt sensor
RQE
Door sensing
White
2
2
Latchbolt sensing
Purple
2
2
Figure 12 Routing the wires
Route wire
harness on
the left side
of the fire
plate.
Mounting
clip and
wire tie
Dress wires so
that wire con-
nectors are
mated here.
Use electric
tape to affix
them as
needed.
Antenna
wire
Summary of Contents for BEST Wi-Q ONGUARD
