V_1.OM.000160.DRM
Page 83
Version 5.0
Doremi Labs, Inc.
18.6 BiPhase Settings
GND
1
TX
MIDI-
2
RX
MIDI+
3
BP-S
4
+5V
5
GND
6
TX
MIDI+
7
RX
MIDI-
8
BP-R
9
DVP400
18.7 Connecting V1 to Audio Workstations & Edit Controllers
18.7.1
Most Common Connection
This connection scheme is used to connect the V1 to StudioFrame, Audiofile, Audiovision, Post-
Pro, Dyaxis II, Protools 4.0 etc.
1. Feed house sync to the V1 and the DAW,
2. Connect the time code out of the V1 to the time code in of the DAW,
3. Connect the serial cable between the V1 RS422 port 1 and the DAW,
Run the DAW software which will control the V1.
18.7.2
Connection to the DAWN workstation (v 4.3c or later)
1. Feed house sync to the V1 and the DAWN
2. Connect the time code out of the DAWN to the time code in of the V1
3. Connect the RS422 port 1 of the V1 to one of the serial ports on the Macintosh
4. Make sure the V1 is in Chase Off mode
5. Make sure the V1 Sync source is “Auto”
6. Run the DAWN software
7. You should see a V1 track at the bottom of the mix view
8. Make sure House Sync is checked
9. Toggle Master/Slave and then make sure you end up in master mode
10. Hit play, both units should play in sync
11. Hit Stop, both units should stop.
The DAWN should always be in master mode.
Pin 5: +5V will provide a 5V power signal
Pin 4: Biphase S signal
Pin 9: Biphase R Signal
Pin 1: Ground Signal
The rest of the pins are used for MIDI chase,
which is still not implemented.
