V_1.OM.000160.DRM
Page 20
Version 5.0
Doremi Labs, Inc.
•
To
erase
a file: hold
OPTION
and press
CLEAR
. Turn the Jog Wheel to browse through
existing files, press
ENTER
to erase the selected file.
4.9 Setup V1 for Playback
Before performing a playback, make sure the V1 has the correct setting parameters.
Basic playback setup is provided below:
1. Connect one of the V1's video output BNCs to a Video Monitor and the XLR audio output
to a speaker.
2. Select
Sync Source
in MENU (3)
and choose Internal Sync. Or select the sync source
connected to the back panel.
3. Exit the MENU by pressing on “
ESCAPE
”
4. To play, go to the desired point of the video and press “
PLAY
”.
4.10 Setup V1 for Record
Before performing a recording, make sure the V1 has the correct setting parameters.
Basic record setup is presented below:
1. Select
Audio Source
in MENU (6)
and select your audio source format (Analog or SDI)
2. To record, locate to the desired point on the drive and hold “
RECORD
“ then press “
PLAY”
or set
Rec at:
to "End F." in OPTION MENU (1) which will cause the V1 to start recording
at the end of the last recorded video.
4.11 Remote Operation
Basic remote operation setup is provided below:
1. Connect your remote controller to RS-422-1 on the V1 back panel.
2. Select
Control
in MENU (1) and choose "
remote
".
3. Select
Transport
in OPTION MENU (1) and press “
++
” until you reach "
Emulate___
"and
select your control protocol.
4.12 Save Current Settings to Memory
To save current setting, do the following:
1. Go to OPTION MENU (5)
Save Stngs
,
2. Press the “
TOGGLE
“ key: LCD displays "Are you sure?",
3. Press the “
ENTER”
key for yes – the V1 will exit the Menu automatically
4.13 Getting the Firmware Version Number of the V1
To get the firmware version number of your V1, do the following:
1. Go to OPTION MENU (00),
2. Press “
++
” key until you reach "V1 y.xx". This is your firmware number. Note that for the
V1-HD, there is also a J2K version displayed as follows: “j2k vers y.xx”.
