V_1.OM.000160.DRM
Page 48
Version 5.0
Doremi Labs, Inc.
Mode 1R/P:
Indicates a standard record or play engine
1R-1P
(optional):
Indicates a simultaneous record and play engine.
To change the mode press the
TOGGLE
key and the hit
ENTER
. You will
next need to save your settings, wait 30 seconds and recycle power on the
V1.
Netpos None:
For all units that are not sharing storage (V1-HD and V1-UHD), it
should be set to None.
To change the mode press the
TOGGLE
key and the hit
ENTER
. You will
next need to save your settings; wait 30 seconds and recycle power on the
V1.
GNet
For V1-UHD and V1-HD with the Gigabit Ethernet Option installed.
All units equipped with the Gigabit option will have 2 Ethernet connectors
on the back panel. The lower connector is the built-in 100BT and the higher
connector is the Gigabit.
Only one of the two connectors can be active
.
The default setting when the unit is ships is Gigabit Enabled.
To switch to100BaseT select “Disable” press ENTER, save settings MENU
(5) and reboot the unit.
To enable Gigabit Ethernet select “Enable” press ENTER, save settings
MENU (5) and reboot the unit.
For best performance, the PC connected to the V1-UHD using Gigabit
should have the Jumbo Mtu set to 7500. To change the Mtu on your PC’s
Gigabit card:
Right click on My Network Places and select Properties
Right click on your Local Area Connection for that card and select
Properties
Click on Configure, Click on Advanced, Click on Jumbo Mtu and select
7500 and hit OK to save all changes.
