V_1.OM.000160.DRM
Page 26
Version 5.0
Doremi Labs, Inc.
•
During segment playback, the remaining time up to the OUT point is shown as
"no. :
MM.SS",
where "no." is the number of the segment played from 001 to 2047, "MM.SS"
is the remaining time up to the OUT point of the segment played in mn:sec
•
During formatting, the message
Formatting
... is shown. During initialize, the message
Initializing
is shown. During drive copy, the message
Copying
... is shown, once done,
Copy Complete
is shown and if source drive has invalid recording,
Bad Param
or
Copy
aborted
is shown.
•
During the drives mounting (insert) and un-mounting (eject), the message
No disk
is
displayed.
The A1, A2, A3, A4 lines of the LCD display the Audio Level meters.
5.2.5 SCSI Drives
The V1 is shipped with either hard-mounted drive(s), a removable drive using a Data-Express or
with external raid5 storage.
When mounted in a removable tray, hard drives can be removed (or installed) while the V1 is
on-line (without the need to shut the unit off).
To remove (or install) a drive, insert the supplied drive key into the key slot on the receiver
below the lit SCSI ID number and turn it clockwise (or counter-clockwise). When removing a
drive, turning the key clockwise will unlock the drive and cut power off from it causing it to spin
down.
Before removing a drive, wait until it has completely finished spinning down.
This will
usually take about 30 to 40 seconds depending on the drive.
5.2.6 LCD Video Display
Figure 21: LCD Video Display
Optional LCD video confidence monitor. The display can be turned OFF or ON in the
CONTROLLER MENU (01)
Video
option.
To
reset
the entire front panel controller (soft reset) hold the
1, 2, 3
or
4
buttons and
press
CLEAR
. This may be necessary to reset the LCD video monitor if you switch
between NTSC frame-rates & PAL frame-rates formats.
