V_1.OM.000160.DRM
Page 53
Version 5.0
Doremi Labs, Inc.
10.6 SCSI Setup
The SCSI Setup settings will set the parameters and configuration of the drive(s). These
settings are pre-configured at the factory (when the drives are purchase from Doremi Labs) and
typically will not require change.
SCSI ID (no.)
Sets the SCSI ID number of the V1 after restart.
Do not use a SCSI ID
number for the V1 that conflicts with any installed drive
. The default
SCSI ID is 7. You need to save and restart to apply the changes.
V1 (type)
Select
Rec/Play
or
Play Only
.
Important
Note
: When the unit is in
Play Only
mode, all operations that
write to the active drive are denied, including record, initialize, format, etc.
Clock
Used to set the SCSI speed in MHz;
Width
Used to set the SCSI bus width;
16bit
Termination
Used to set the Termination mode;
This should always be set to ON.
Warning: You should not set the termination to off unless it was originally configured by
Doremi or when requested by a Doremi Labs technician.
10.7 Media Setup
To activate the commands in this section, press
TOGGLE
. The message “Are you sure?” will
appear on the LCD screen. To accept press
ENTER
. If you change your mind press
ESCAPE
.
Mount
If you have more than one drive/MD powered up, this command will mount
the next available MD.
Init
The
Initialize
command deletes all previous recordings and files (clips),
and writes all the new set-up parameters selected in the menus on the
active drive. A disk that was never initialized on the V1 will display the
message “No MD Present” until it gets initialized.
CAUTION NOTE !!
Ensure that the settings under OPTION MENU (4)
Init Disk
are set
properly before initializing the drive.
10.8
Disk Copy
The Disk Copy functions will allow you to copy a whole file or a segment within the same disk or
from one disk to another. The copy operation is based on a Copy Paste approach.
•
Load the source file
•
Locate to the start of the segment you want to copy and press
IN
(optional)
•
Locate to the end of the segment you want to copy and press
OUT
(optional)
•
Go to OPTION MENU (8), the display should be “
Copy 1 File ?
”, hit
ENTER
to mark the
segment or file for copy.
•
The display will show you the file name and if you press
++
, it will show you the IN and
OUT points followed by the “
PASTE ?
” prompt.
